How To Use A Step Drill Bit. Drill bits come in various shapes and sizes and are designed to drill holes on different surfaces. However, they can also drill through wood, plastic, or acrylic.
Drillpro 84 95 106mm Twist Step Drill Bit For Woodworking Kreg from alexnld.com
This will have a clear location for the positioning and capture of the drill bit. At this point, apply a lubricant and tapping fluid up to the desired diameter. Use a step drill bit with a tap wrench to make holes for screws.
*Note That Some Step Drill Bits Require The Use Of A Punch Before You Begin Drilling.
The shape of the step drill bit is similar to a cone, thus avoid the requirement of. The main function of a step drill bit is to make holes of varying diameters within a sheet of metal or other surfaces. A step drill bit is a specially designed bit that can create multiple diameter holes using a single one.
They Are Mainly Used In The Sectors.
Slowly drill the hole to whatever depth is needed to achieve the correct hole diameter. A typical step drill bit kit comes with. However, it can also be used to make small holes larger or deeper.
Using A Center Punch, Create A Pilot Hole Then Introduce The Tip Of The Step Bit.
To open the chuck by hand, hold the chuck with one hand. This will help to prevent the step drill bit from slipping. You can tap, drill and deburr in one step with the step drill.
This Is Due To The Split Point Being Much Broader (135 Degrees) As Opposed To Your Standard 118 Degree Drill Point.
At the exact point where the hole is to be drilled, you need to position the tip of the center punch. To avoid drilling in the wrong place, mark the exact location using a marker. Each step on the bit is larger in diameter than the step before.
Drill A Pilot Hole In The Wood Using A Regular Drill Bit.
Step drill bits are used to drill metal up to 1/4 of an inch thick. Nonetheless, be careful not to go overboard as you can easily damage that portion of the nail too. If you have the exact position, you can strike the blunt end of the center punch with a hammer.
Post a Comment for "How To Use A Step Drill Bit"